|
06-13-2009, 08:55 PM
|
#1
|
Winnebago Owner
Join Date: Nov 2001
Location: Santa Clara,CA. USA
Posts: 60
|
Dish Washer
I need to remove the dish washer in my 2005 Itasca Horizon, so could use a little up front advice rather than a learn as I go. Must remove the whole thing to get to some wiring in the back.
Don, WIT 70041
|
|
|
06-13-2009, 09:29 PM
|
#2
|
Winnebago Watcher
Join Date: Mar 2008
Location: could be any where
Posts: 3
|
What make is the dish washer.
__________________
Bob & Mary Ann 06 Mountain Aire, NKK,FMCA
07 Ford Edge, 2014 Victory Cross Country Tour
Jada, boston terry,coconut 4 1/2 lb terrror, Chihuahua
|
|
|
06-14-2009, 08:27 AM
|
#3
|
Winnebago Camper
Join Date: May 2009
Posts: 49
|
Can't you just ask her to move?
__________________
Jim
2009 Vectra 40WD
|
|
|
06-14-2009, 04:55 PM
|
#4
|
Winnebago Watcher
Join Date: Mar 2008
Location: could be any where
Posts: 3
|
Good one, but I do not think that is the answer he is look for. Myself, I would give the dish washer a credit card to go shopping, and move the rig
__________________
Bob & Mary Ann 06 Mountain Aire, NKK,FMCA
07 Ford Edge, 2014 Victory Cross Country Tour
Jada, boston terry,coconut 4 1/2 lb terrror, Chihuahua
|
|
|
06-14-2009, 05:02 PM
|
#5
|
Winnebago Master
Join Date: Aug 2005
Location: Nashua, NH
Posts: 1,838
|
If you have a Fisher Paykel DishDrawer here's a link to a set of Install instructions--perhaps they will help with an uninstall: http://fisherpaykelparts.net/partman...nstall_USw.pdf
__________________
Chris Beierl
2005 Winnebago Vectra 36RD
|
|
|
06-14-2009, 07:58 PM
|
#6
|
Winnebago Watcher
Join Date: Mar 2008
Location: could be any where
Posts: 3
|
Dish Washer
Fisher Paykel Drawer removeal
First you have to take the drawer out of the cabinet, To do this you need to remove the clips on the drawer slides. Then pull the drawer off of the slides. Turn the drawer 90 deg to your left and set the drawer on a milk carte ( the wires and hoses are to short to set the drawer on the floor). You are now you can see the screws that hold the cabinet in place. Do check the top and sides as well as the bottom for the mounting screws.
I hope this helps.
Bob, Two dish washer, Two dogs
__________________
Bob & Mary Ann 06 Mountain Aire, NKK,FMCA
07 Ford Edge, 2014 Victory Cross Country Tour
Jada, boston terry,coconut 4 1/2 lb terrror, Chihuahua
|
|
|
06-16-2009, 04:06 AM
|
#7
|
Winnebago Owner
Join Date: Nov 2001
Location: Santa Clara,CA. USA
Posts: 60
|
Thanks, just the info I needed. If I get it out think I will leave it out and revert back to the one I got some 50, years ago for 2, bucks. The one I have now ruins the paper plates. If I can find why I lost power to my outlets in the kitchen I would be a happier camper. Yes I did check the GFI.
Don, WIT 70041
|
|
|
06-16-2009, 05:08 AM
|
#8
|
Winnebago Master
Join Date: Jun 2004
Location: SW Florida
Posts: 773
|
Don - I know you checked the GFI, but don't overlook the fact that the GFI can fail. My kitchen GFI failed a few years ago and there were no symptoms other than no power at or downstream of the GFI.
I pulled it out slightly and checked it with a meter - power in, but no power out no matter how many times I tripped and reset it. Replaced it with one from Home Depot and have had no further problems....good luck.
__________________
Tom
'04 Journey 36G - Cat C7
'04 Honda CR-V
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|