Need help with bedroom slide

[Reno Rascal]

Since this is the most knowledgeable group of RVers that I have ever encountered, I will throw a question out to you. I have a 2005 Itasca Sunrise on a Workhorse 33v Chassis. My bedroom slide out wend dead. I checked the fuse, power, and the controller; all are good. I get no lights on the control switch and cannot place it in manual mode so I don't think is getting any power. The parking brake is set and the front slide works. I know that there is a relay in line somewhere but I cannot find it anywhere. Does anyone know the location of this relay? Any help offered is greatly appreciated.

[plasma800]

Change the switch first. They go bad. Should be able to find one from camping world sub $20.

[Reno Rascal]

Thanks but I did swap out the switch for the one on the front slide and it works there, just not in the back. I don't think the switch is at fault.

[plasma800]

Might find the slide controller by tracing a wiring diagram from here.

Wiring Diagrams

[plasma800]

Post number 4 here might help, didn't read past #4 myself, but you might.

http://www.irv2.com/forums/f101/2005...uts-18866.html

Actually, post 8 references the control board location for the rear slide.

[Reno Rascal]

Thanks guys, the problem is fixed. I found the controller board in the storage compartment below the bedroom. There was a loose wire to that board from a previous repair. I reattached the wire and it all works fine now. Thanks also for the link to the wiring diagrams from Winnebago, they are extremely useful.

[plasma800]

Excellent!