A couple of turns of electrical tape around the keeper is a old fix If it starts to rattle again just replace the tape. Also a teflon coated keeper is available and this too helps. Good luck
__________________
Happy Trails! ICHN2GO, Seaford VA,
06, 34 Newmar Ventana
02 Jeep Liberty
Teflon coated keeper is waste of money, IMO...I tried that. The electrical tape works fine. Just need to replace it occasionally.
__________________
'07 Country Coach Allure 470 Siskiyou Summit #31578, Cummins ISL 425; 2014 Ford F150 toad; Air Force One Toad Brake.
Glen Allen, VA; Smith Mountain Lake, VA.
I got a piece of bearing grade plastic and cut it down to fit under the bottom corner of door (lock side) just thick enough to stop door from moving up and down. I taped two screws in bottom of the door and counter sink the screws in the plastic so they do not rub door sil.No more door movement
It was the "keeper" that did it on ours. I placed a small piece of velcro on the door and wrapped a turn around the keeper. It's been on their for a year and a half.
You could have DW (or DH - depending) run alongside and hold the keeper up.
__________________
Wayne MSGT USMC (Ret) & Earlene (CinCHouse)
2015 Winnebago Tour 42QD - 2020 Lincoln Nautilus Reserve (TOAD)
(RVM-14) It is what it is, and then it is what you make of it.