|
03-19-2013, 11:36 AM
|
#1
|
Winnebago Owner
Join Date: Feb 2012
Location: Oak Ridge, TN
Posts: 211
|
Silverleaf VMSpc- Where is that darn plug?
Hi Everyone - I am looking at ordering the SilverLeaf VMSpc adapter for my laptop to monitor the engine becuase I really don't have enough things to look at as I drive down the road but I can't find the diagnostic port/plug under the steering column. I crawled under there this weekend but didn't see it. I wanted to see if I needed the 6 or 9 pin version. Does anyone have a picture of where theirs is and what it looks like?
2003 Journey DL 36GD 330 Cat
VMSpc | SilverLeaf Electronics, Inc.
Thanks
Ben
__________________
2019 Minnie Winnie 22M | 2011 Honda CRV "Serenity Now!"
|
|
|
03-19-2013, 11:47 AM
|
#2
|
Winnebago Watcher
Join Date: May 2012
Location: Edmonds, WA
Posts: 1
|
The ScangaugeD plugs into the same connection. Click this link and the two different plugs are shown half way down the screen on the right.
__________________
'04 National TropiCal T350 Behind the coach:
|
|
|
03-19-2013, 11:59 AM
|
#3
|
Winnebago Owner
Join Date: Feb 2012
Location: Oak Ridge, TN
Posts: 211
|
Thanks mbrandt1402. Thats kinda of what I thought it looked like. Now I'm just hoping someone with the same/similar coach can tell me where it is. There is a huge bundle of wires tie wrapped there and I hated to release that mess if I didn't have to. From other posts it sounds like it is clipped to the wall somewhere. I do like the price of the ScanGaugeD a little more!
__________________
2019 Minnie Winnie 22M | 2011 Honda CRV "Serenity Now!"
|
|
|
03-19-2013, 12:20 PM
|
#4
|
Winnebago Camper
Join Date: Jan 2013
Location: Northeast PA
Posts: 10
|
I just installed the scangauge d this past weekend in my 2004 Journey 34H.
Mine was behind the steering wheel bolted to the firewall. Took me 3 times looking before i found it. it is well hidden.
hope this helps.
__________________
2004 Journey 34H, 350 C7
Frank, Kellee (& Harley)
|
|
|
03-19-2013, 02:21 PM
|
#5
|
Winnie-Wise
Join Date: Oct 2009
Location: NE WA or S TX
Posts: 300
|
In mine it is below the dash left of the collum, it had a cap on it. Grayish/brown in color.
__________________
04 Horizon QD, 12 Ford Flex, Excalibar, Brakemaster, Winter Texan, RVin! since 1974
Norm, Donna 01 Z3
Life is a Timed Event, you only get One Go Around!
|
|
|
03-19-2013, 09:14 PM
|
#6
|
Winnebago Camper
Join Date: Mar 2013
Posts: 22
|
On my 02 Ultimate
It is located behind the kick panel on the lower left of the steering column. Pain in the a$$ to get the kick panel off and then back on. It is a carpeted piece of metal and I have to lift the edge of the glued down carpet to get to the screws.
lenp
|
|
|
03-20-2013, 05:13 AM
|
#7
|
Winnebago Owner
Join Date: Feb 2012
Location: Oak Ridge, TN
Posts: 211
|
Thanks lenp! Are you talking about the wedge shaped foot rest thing on the floor for the left foot? I did move mine but there was some box for the surround sound system on the back side of it. Maybe the plug was there and I just didn't look close enough?? And yes the carpet makes it a pain to get the screws back on. Heck who needs all those screws. 1 should hold it
__________________
2019 Minnie Winnie 22M | 2011 Honda CRV "Serenity Now!"
|
|
|
03-20-2013, 06:13 AM
|
#8
|
Winnebago Camper
Join Date: Apr 2012
Location: Louisville, KY
Posts: 25
|
Totally different coach, but on my Freightliner it was to the RIGHT of the steering column tucked up over a defrost duct.
__________________
Mark Anderson - FMCA 351514 - Louisville, KY
2007 Sportscoach Pathfinder 377DS - Freightliner XC
2006 Jeep Commander
Cricket SW3 Personal Transporter
|
|
|
03-20-2013, 07:05 AM
|
#9
|
Winnebago Owner
Join Date: Feb 2008
Posts: 181
|
Remove the kick panel and get a flashlight. Mine was on the left side of the steering column on the firewall. Look for a grey round cap.
|
|
|
03-20-2013, 03:01 PM
|
#10
|
Winnebago Camper
Join Date: Oct 2010
Location: Winnsboro, TX
Posts: 27
|
Mine is mounted high on the firewall to the left of the steering column, almost to the left wall. By moving wire bundles and heater ducts around I can see it but not reach it from below. I removed the instrument panel top cover and I could reach it but not see it from above. I connected the cable from above and left the wire sticking out from the cover to connect to the USB port on my computer. There should be an identical connector in the engine compartment so you can verify the type and number of pins.
Bill
|
|
|
03-20-2013, 03:10 PM
|
#11
|
Winnebago Owner
Join Date: Feb 2012
Location: Oak Ridge, TN
Posts: 211
|
Thanks everyone I will go on another hunting expedition this weekend. I think I was frightened off from poking around too much by the mass of cables under there. After looking at the ScanGuage web site I'm starting to think I may go that route due to the cost difference. Although the VMSpc looks really cool!
__________________
2019 Minnie Winnie 22M | 2011 Honda CRV "Serenity Now!"
|
|
|
03-20-2013, 10:53 PM
|
#12
|
Winnebago Owner
Join Date: Apr 2007
Posts: 115
|
AS others have posted mine is about 6inches above floor to the left of steering column
__________________
2001 Horizon 2004 jeep GC
|
|
|
03-22-2013, 01:56 PM
|
#13
|
Winnebago Camper
Join Date: Oct 2011
Location: Orlando, FL
Posts: 19
|
I also hooked up the VMSpc on my 04 Journey, 36G had to really look for the plug, took me 2 or 3 times. Mine was same as others have said, mounted in a bracket on the firewall a few inches above the floor, can't remember if it was directly behind the steering shaft or offset a little, but it is behind a bundle of wires. Mine was the larger of the two adapters. Hope that helps!
__________________
Randy, Cindy and Mickey (Our Rat Terrier)
2009 American Tradition 42C
Cadillac SRX/Blue Ox/Air Force One
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|