 |
05-04-2015, 03:08 PM
|
#1
|
|
Winnebago Watcher
Join Date: May 2015
Posts: 4
|
1999 Winnebago Adventurer F-53 V-10
Where is service connector for pulling codes looked everywhere with no luck please help?????????????
|
|
|
|
05-04-2015, 03:16 PM
|
#2
|
|
Winnie-Wise
Join Date: Apr 2011
Location: Powell River, B.C.
Posts: 339
|
:welcome:
OBD II connector should be close to the steering column on the bottom of the dash. You may have to lay on the floor and look straight up.
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
|
|
|
|
|
05-04-2015, 03:17 PM
|
#3
|
|
Winnebago Watcher
Join Date: May 2015
Posts: 4
|
1999 f53
Its obd 1 not two
|
|
|
|
|
05-04-2015, 03:31 PM
|
#4
|
|
Winnebago Owner
Join Date: Sep 2010
Location: Marquette, Michigan "Da UP"
Posts: 219
|
:welcome:
Good luck with your search.
__________________
John & Cathy R.
06 Pace Arrow 38L W24
08 Lincoln MKX AWD
See My RV Upgrades
|
|
|
|
|
05-04-2015, 06:35 PM
|
#5
|
|
Winnie-Wise
Join Date: Apr 2011
Location: Powell River, B.C.
Posts: 339
|
Quote:
Originally Posted by fstcobras666
Its obd 1 not two
|
OBD I connectors were sometimes under the hood , my 93 Dakota was there , but in 1996 , the OBD II was mandated by the federal government and required to be within 2' of the steering column.
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
|
|
|
|
|
05-05-2015, 08:57 AM
|
#6
|
|
Winnebago Watcher
Join Date: May 2015
Posts: 4
|
reply
well this m/h is 18,000 heavy duty and uses obd I with this v-10 ford 6.8 L ford
powerplant it is common on anything over 14,000. i know this cuz im am ase certified smog tech. i know where connectors normaly are but this one is hard to find guess i'll keep looking.
|
|
|
|
|
05-05-2015, 11:11 AM
|
#7
|
|
Winnebago Watcher
Join Date: Dec 2014
Location: Northeast Ohio
Posts: 3
|
I found mine attached with a screw to the right side of the plastic steering column cover, up behind the dash. I removed the screw so it could drop down to attach an NGS (Ford scan tool) and then just tucked it back up when I was done.
__________________
2000 Fleetwood Southwind 32V - Ford F53 V10 6.8L
|
|
|
|
|
05-05-2015, 12:24 PM
|
#8
|
|
Winnebago Owner
Join Date: Oct 2011
Location: Charleston, SC
Posts: 80
|
I have a 2000 Ford F-53 and mine is OBD II tucked in the wiring next to the steering column under the dash. As far as I know, this was the standard plug for all vehicles after 1996.
__________________
Nathan and Linda, 2000 Winnebago Chieftain 35U, F53 Chassis, Banks Power Pack
|
|
|
|
|
05-05-2015, 04:47 PM
|
#9
|
|
Winnebago Master
Join Date: Dec 2005
Location: Buxton, North Dakota
Posts: 1,037
|
I have a 1999 Winnebago Brave 35C with F-53 chassis. Lif up the dash, it is just too the right of the steering column. Mine works fine as OBD II with Scanguage II.
__________________
2003 Winnebago Adventurer 38G F53/ V10 605 watts of Solar
1999 Winnebago Brave 35C Handicap Equipped
F53/V10
1999 Jeep Cherokee & 1991 Jeep Wrangler Renegade
|
|
|
|
|
05-05-2015, 09:10 PM
|
#10
|
|
Winnebago Watcher
Join Date: May 2015
Posts: 4
|
is yours obd I or II
|
|
|
|
|
05-06-2015, 12:24 AM
|
#11
|
|
Winnebago Watcher
Join Date: Jan 2014
Location: Hesperia, California
Posts: 2
|
My 1999 brave 35c, Chevy p-30 is OBDII also and its to the left of the steering column tucked underneath
__________________
1999 Winnebago Brave 35C
|
|
|
|
|
05-06-2015, 12:40 AM
|
#12
|
|
Winnebago Camper
Join Date: Sep 2010
Location: Horse Town USA, CA.
Posts: 13
|
Quote:
Originally Posted by fstcobras666
Its obd 1 not two
|
My 99 F53 is ODB II. The ODB II connector is on the right side of the steering column. If it's a 97 its ODB I, there was no 98 F53. All F53's with the V10 are ODB II.
__________________
Chuck & Teri, 1999 35 ft. Dolphin 5350, F53 Chassis Chassis build date 1/99, Banks System, 5 Stars Tune, Air Lift Air Bags front & rear, Koni Shocks, Blue OX TruCenter, TigerTrak track bars front & rear, Roadmaster 1-3/4" rear auxiliary sway bar, 2004 F450 6.0 Diesel Crew Cab DRW with B & W Custom Truck Bed, 1994 36 ft. Avion 5th Wheel
|
|
|
|
|
05-08-2015, 11:56 AM
|
#13
|
|
Winnebago Owner
Join Date: Jan 2012
Location: Kentville, NS
Posts: 134
|
On my '99 Chieftain F53 the ODB II is accessible by removing the black plastic cover below the steering column. I leave the cable for my Scan Gage II connected all the time.
__________________
_______________________________________
Binnie, Wanda & Yasper (Labradoodle)
1999 Winnebago Chieftain 35U F53 Chassis V10
Towing 2014 Jeep Wrangler Sahara
|
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Linear Mode
