Front jacks seesaw (for lack of a better term)

[steved28]

So I just noticed this after a year of ownership, so I'm not sure if it was always the case. But I noticed one of my front jacks was showing about an inch or more of piston while they were in the up position. Indications on my control were that they were up and all is fine. I placed a 2x4 as a fulcrum under it and it came up the rest of the way with ease. Then I noticed it had forced the other front jack down the same distance. I forced that one up, and the other went down. Is this normal behaviour that I just never noticed?

[WoodBoss]

No that is not normal. Did you have the controller in stow mode? Sounds like it's not letting fluid back into the tank but rather pushing it into the other cylinder.