Help! 115VAC dead on roadtrip 2024 Micro Minnie 2108FBS

[Wmlunt]

2024 Micro Minnie 2108FBS
All 115VAC outlets (inverter prepped) dead. Doesn’t work on shore power, or off the batteries on inverter. Rang out the shore power cord and checked/reset all breakers at the panel.
Microwave works, so not all 115VAC is dead, maybe one leg?
The dealership installed the inverter, maybe they made a lousy connection somewhere…
Found one 30 amp inline fuse in a really corroded, and full of water, holder under the frame up by the battery -near the self resetting 12V hot breakers.
Looked for a breaker in the angled box marked “inverter prep” in the pass thru, Nada…
I’m guessing bad crimp by installer either at the back of the breaker box, or converter? Maybe where they tied in to the inverter prep circuit ( by the kitchen sink plug?)
Any help greatly appreciated!
TIA Bill

[be happy]

Have you checked the gfci outlets, you have at least one maybe two. They may need to be reset. There also is a breaker on the invertor I believe that you may want to check.

As long as you are around the breaker panel you might as well unplug from power source, unscrew breaker panel cover and tighted ALL screws holding down power wires. Who knows maybe the invertor install folks failed to rewire a breaker.

Good Luck

[Wmlunt]

GFCI it was!
Thanks be Happy!
I was looking for the reset in the breaker, and there it was on the outlet right in my face.
Thanks again!
Bill

[IdahoHunter]

Originally Posted by Wmlunt

GFCI it was!
Thanks be Happy!
I was looking for the reset in the breaker, and there it was on the outlet right in my face.
Thanks again!
Bill

Outlet on the sink cabinet on the left as you come in the door?

Sounds like the inline fuse that you found full of water may be the one for the tongue jack. Is that correct?

[Wmlunt]

Yes,that was the tongue jack fuse!
Miserable location!
As we are on the road I replaced the fuse after soaking with contact cleaner and sealed with electrical tape.