Picture 4 of 4 from Album Micro Minnie Axle Riser
|
|
Minnie Axle Riser Rev2
The holes in the existing mounting plates are oblong so the holes in the riser do not have to be oblong. Drill as per drawing.
I had my local fab shop bend up a 3 1/2" x 2" x 3/16" (7 GA) U Channel. I drilled the 11/16" dia holes and welded in 3/16" plate Gussets.
I could have started with 3 1/2" x 3 1/2" x 3/16" (7 GA) Square Hollow Structural Steel Tubing. Then Zip cut the square to make 3 1/2" x 2" U Channel.
A third option is to use 3 1/2" x 3 1/2" x 1/4" Square Tubing and not cut it into U Channel, drill 11/16" holes and your done. |
Picture Added 04-25-2023 02:16 PM
Added by Bcborn
|
|
Disclaimer:
This website is not affiliated with or endorsed by Winnebago Industries or any of its affiliates. This is an independent, unofficial site.
All times are GMT -6. The time now is 07:29 AM.